The Landing Loop™ Float Kit™ was designed to make your Landing Loop™ float in case it should fall overboard. Just follow the simple instructions below and both pieces as well as the entire Landing Loop™ will stay afloat until you can retrieve it. Do not leave the Landing Loop™ in water for an extended time. Be sure to rinse it off with clear tap water and allow it to dry thoroughly before storing.

To assemble the Float Kit™:

1. Insert small piece of foam into end of pole.

2. Coax foam into end of pole as shown...
DO NOT TRIM piece of foam.

 

3. Foam piece should fit snugly inside the end of pole. The foam piece will seat itself when you attach the frame to the end of the pole.

4. Place the two foam sleeves around the frame as shown and hold them in place with the two cable ties.

See the Special Combo Offers
(When shipped in the same
box as your Landing Loop™)