Welcome to LandingLoop.com
Home | Detailed Instructions | About Us | Place Order | Play Video | Images/Instr. Demo | Captain's Blog | Become a Dealer | Join our Mail List
LandingLoop™ Will Revolutionize Your Boat Docking |
LANDINGLOOP™ DOCKING TIPS
Never Jump off your boat again when approaching a docking situation
Please click below for full Instructional Demo
Please note: The video is large and may take a few seconds to download. Thank you for your patience.
Picture#1 shows how to pre-mark the docking line to be used with the Landing Loop. Place a mark on the line at the location of where it meets the two tips of your line that is laying in front of the Landing Loop frame. The first mark should be approximately 6 inches into the line from the manufacture's preformed loop. These marks should be permanent markings and remain on that line. |
Picture #2: Make a slip knot in your line out of the manufacturer's pre-formed loop. Then hold the pre-marked docking line as shown and place the two spots on to the two tips on the underside of the Landing Loop frame. |
Picture #3: Notice how the line forms a loop around the Landing Loop Frame. Be sure to keep the line on the bottom side of the frame when using the Landing Loop for docking. |
Picture #4: The Landing Loop is loaded and ready to be used once the pole is extended. |
| Extend your Landing Loop over the piling keeping the rope tight. |
Once over the piling, loosen the rope until it slides down the piling and remove your landing loop being careful not to let go of the rope. |
Home | Detailed Instructions | About Us | Place Order | Play Video | Images/Instr. Demo | Captain's Blog | Become a Dealer | Join our Mail List
© 2010 Gadgets Unlimited, Inc.
3714 Runge Street, Franklin Park, IL 60131
Customer Service: 1-800-250-9545
E-mail: Info@landingloop.com