Welcome to a new way of docking. The LandingLoop™ will revolutionize the way you dock your boat.

(You can save and/or print this page from your browser File menu)

Here's how easy it is to use.

When you receive your new Landing Loop, look it over and place the frame on to the pole. WATCH THE VIDEO INCLUDED IN YOUR PACKAGE. It will explain the entire docking procedure.

Step One
Assign one or several of your 25Ft or 35ft lines to be used with the LandingLoop™. Then place your LandingLoop™ with the frame attached on to the pier as shown. Place your line in front of the frame as shown. Place a mark using waxed twine, or water proof tape about 6 inches away from the pre formed loop on your line and align that mark with one of the LandingLoop™ tips. Then place another mark on the line that aligns with the other tip of your LandingLoop™. (This procedure will be done this one time only and will assist you later when you load the frame for docking.

Step Three
Make a slip knot using the pre formed loop on your docking line as shown in No 3. Notice how your pre marked spots appear on the slip knot.

Step Four
Hold the line at the two pre marked spots that you placed on the line in Step One.

Step Five
Place the two pre marked spots of your line on to the two tips of the LandingLoop™ Frame. It will make a large loop around the frame of your LandingLoop.

Step Six
At the direction of the boat's captain, extend the pole as needed. The pole will extend up to approx 11 feet. Keep a slight tension on the line as it slides through your hands as you extend the pole.

Step Seven
As soon as the loop on the loaded frame is around the cleat release the tension from the line, remove the frame, and pull the line tight. Place the LandingLoop™ frame on the boat and tie down your boat as directed by the captain. It is recommended to use two LandingLoops™. Use one on the bow and one on the stern to assure that there are two lines securing the boat.

Congratulations!!!!!! Your boat is now safely tied to the dock. The captain should re-establish all his permanent docking lines and secure his boat as needed.

PLEASE REMEMBER --- It is the responsibility of the boat's captain to watch the instructional video and train his mates in the proper use of the LandingLoop™. He must also be sure his crew knows their specific roles in each docking experience when using the Landing Loop. This includes practicing on land and while the boat is docked before leaving the pier.

Do not use the LandingLoop™ as a boat hook or for any other purpose than extending a docking line on to a cleat, pole, or piling on a dock.

Please be sure to read the security and policy pages on this Web site before using the LandingLoop™ for docking.